Reclining Sofa With Drop Down Table

The first reclining armchair was introduced by the lay-z-boy company in 1928. Today many companies make motion furniture, as the industry calls it and the term recliner no longer refers to just armchairs. You can buy reclining, couches and even reclining sectionals. This factory makes reclining chairs and couches in both fabric and leather. The furniture construction is the same regardless of the material. However, leather upholstery requires a few extra steps. They begin by inspecting the hidden marking, serious defects with one color of tape and minor imperfections with another. A computer program cutting machine scans and registers the tape markings then automatically cuts and discards. The defective parts it cuts upholstery pieces for hidden areas such as the undersides of a seat, cushions from the imperfect leather and visible parts from a flawless leather. Once all the pieces are cut, they sew together the back seat and arms. Then they stuff the arms and back they position the open end against a blowing machine that fills it with polyester fiber workers weigh each part before and after filling. This ensures they’ve blown in the right amount of fiber and also that both arms have the equal filling.

Next, they’ll fill the seat with foam a compression machine squeezes it then a worker sprays on silicone lubricant. This enables the seat cover to slide on easily foam is made of a chemical mixture, the formulation of which determines the density, the higher the density, the higher the quality elsewhere in the factory. Meanwhile, they cut the frame components from plywood using a computer-guided bandsaw. These long pieces will form the seat frame. A three seater couch has three separate frames: enabling each seat to recline individually machine lines, one side of each piece with steel spring clips, a worker, then dabs the ends in glue and assembles the pieces, reinforcing them with long glue coded staples as the staples enter. The wood friction generated, heat melts the glue.

The glue then tries securing the staples. Now comes the step is known as springing the seat they hook. Five thick steel springs into the spring clips then hammer the clips close to locking the springs in place. They connect the springs with a plastic covered wire so that when you sit on the seat, all the springs react in unison. They assemble the frame pieces for the arm using glue and glue, coat and staples again, plus a few screws at strategic points. They screw the arm to the seat and begin a pull string. First, a layer of felt to cushion the springs. Then wood cardboard and foam to form the rounded shape of the armrest after lubricating with silicone spray they slip on the leather and staple it into place. They upholster the backrest and sides in the same manner.

The reclining mechanism arrives at the factory with the sides. Preassembled workers install the connecting pieces, then a bushing that reduces the noise. The mechanism makes then a spring to control the recline speed. They screw. The mechanism to the seat frame then hook up the operating, handle and test it out to cover the back of the furniture they attach to metal. Tacking strips to the leather then turn the edge under and hammer the tacks into the frame using a pneumatic hammer. The last step is to attach the back to the seat. There is a detachable flap at the bottom, providing access to a locking spring inside that lets. You remove the back if you have trouble getting the furniture through a doorway at this factory. Workers are encouraged to lie down on the job, but only to inspect the furniture after examining the fabric and sewing they assess the comfort and test.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Recent Posts



GiottoPress by Enrique Chavez